GMP Model J2 Cable Lasher

The Model J2 Cable Lasher is used to lash a single aerial cable or numerous cables to a supporting strand or to an existing lashed cable with stainless steel lashing wire. Will lash any single or multiple aerial cables up to 3 in. (76mm) diameter across on any suspension strand from 1/4 in. (6mm) to 7/16 in. (11mm). A factory modification will allow the lasher to accommodate 1/2 in. (12.7mm) strand if necessary. The J2 and every GMP lasher are fully serviceable to "good-as-new" specifications at our factory and at factory-trained service locations around the globe. J2 Lashers make overlashing easy. Just push down on the strand roller knob, rotate it a quarter turn and you can lash additional cables together on previously lashed cable. Pre-drilled and tapped at the factory for mounting of the lasher guard or "halo". For use when lashing in overgrown areas.The lasher is furnished with a rugged lightweight storage chest with corrosion-resistant hardware, recessed latches, and a moisture-proof, tongue-in-groove design for maximum protection when not in use.

Features:

• Two recessed magazines capable of holding
  • 1200' of 0.045"       365m of 1.1mm
  • 450' of 0.065"
• Quick coil loading
• Automatic drum lock for easy span transfers and smooth forward travel
• Contains sealed and oilless bearings to minimize maintenance and assure durability
• Easy overlashing
• Constructed with heat-treated, plated steel, stainless steel, brass, and aluminum components. 
• Positive internal gear to gear mechanism has no chains or belts to stretch, slip or break
• Will lash any single or multiple aerial cables up to 3 in. (76 mm) diameter across on any suspension strand from 1/4 in. (6 mm) to 7/16 in. (11 mm).
• A factory modification will allow the lasher to accommodate 1/2 in. (12.7 mm) strand if necessary.

Kit Includes:

• 6 ft. bridle rope assembly
• snap hooks
• operation manual
• Lightweight storage chest